RO reverse osmosis purified water equipment ten failures and maintenance methods

RO reverse osmosis purified water equipment ten failures and maintenance methods

• First, the switch is on, but the device does not start:
• Electrical line failure, such as bad insurance, wire fall off
• The thermal protection element does not reset after protection

The solution:

• Water undervoltage, check the insurance, check the wiring
• Reset the thermal protection element
• Check waterways to ensure water supply pressure
• Second, after the equipment is started, the water inlet solenoid valve is not opened:
• Cables are disconnected
• The internal mechanical fault of the solenoid valve occurs
• The solenoid valve coil is faulty

The solution:

• Check the cable
• Remove the solenoid valve for repair
• Repair or replace the coil
• Third, the pump operation, but not up to the rated pressure and flow:
• Pump reversal
• The security filter element is dirty
• There is air in the pump
• Flush the solenoid valve to open

Solution:

• Reconnect cables
• Clean or replace the filter element
• Remove air from the pump
• Adjust the pressure after rinse
• Fourth, when the system pressure rises, the pump noise is large
• Raw water flow is not enough
• Raw water flow is unstable

Solution:

• Check the original water pump and pipes
• Check whether the original water pump and pipes are leaking
• The solenoid valve is not closed after washing
• The control components and circuits of the solenoid valve are faulty
• The solenoid valve is faulty

The solution:

• Check or replace components and circuits
• Remove the solenoid valve and repair or replace it
• Sixth, under voltage stop
• Insufficient supply of raw water
• The security filter element is blocked
• Improper pressure adjustment, automatic flushing caused by underpressure

The solution:

• Check whether the original water pump and pretreatment system are working
• Clean and replace the filter element 3. Adjust the system pressure to the best state, so that the filter pressure is maintained at more than 20psi
• Seven, the concentrated water pressure does not reach the rated value
• Pipeline leakage
• The flushing solenoid valve is not fully closed
• The recycling system is leaked

The solution:

• Check and repair pipes
• Check and replace the flushing solenoid valve
• Check and repair the recycling system
• Eight, the pressure is enough, but the pressure display is not in place
• The pressure gauge hose is blocked with foreign matter
• There is air in hose
• The pressure gauge is faulty

The solution:

• Check and dredge pipes
• Remove air
• Replace the pressure gauge
• Nine, the water quality deteriorates
• Membrane contamination and scaling
• The seal of the membrane junction fails due to aging

The solution:

• Chemical cleaning according to technical requirements
• Replace the O-ring
• Replace the membrane
• Ten. Decline in production
• Membrane contamination, scaling, chemical cleaning according to technical requirements
• Water temperature change is determined by recalculating the actual water temperature.