The method of removing residual gas in water purification equipment is introduced
In the process of using purified water equipment, sometimes there will be gas in purified water equipment, if not treated in time, it will affect the use of equipment, then how to effectively eliminate the residual gas in purified water equipment?
Effective methods for removing residual gas in purified water equipment are as follows:
When industrial water purification equipment starts to operate again, the gas in the equipment does not exhaust the rapid pressure boost operation.
Solution: Exhaust the remaining air at a pressure of two to four pars, and then gradually increase the pressure.
When the joint seal between the pretreatment system of industrial purified water equipment and the high pressure pump is not good or the pretreatment water supply is insufficient, such as the blockage of the micro-filter, there will be air in the place where the seal is not good.
Solution: The microfilter should be cleaned or replaced to ensure that the pipeline does not leak.
